flame control

SSPC Corporate Member

ICC International Code Council

National Paints and Coatings Association

 

Flame Control Coatings, LLC

flame control

The Ultimate in Fire Protective Coatings
and Heat Resistant Coatings

flame controlSite Mapflame controlHomeflame controlAbout Usflame controlFire Retardant Coatingsflame controlHeat Resistant Coatingsflame controlTemperKoteflame controlDistributorsflame controlContact Us

Thermal Cladding for Structural Steel

Fire Retardant Paints

Varnishes & Clears

Primers & Sealers

Fabric Coatings

Specialty Construction Products

Heat Resistant Coatings

Aircraft Coatings

Specialty Construction Products

 

Introduction to Flame Control Specialty Construction Products

flame control

flame control

FC Fire Retardant Mastic No. 50-44 Low VOC

Flame Control No. 50-44 is an asbestos free, reinforced intumescent thermal protective coating, designed for application to interior structural steel, where it is necessary or desirous to increase the steel fire endurance time up to one hour.

flame control

flame control

FC No. 50-44 Application Guide

flame control

flame control

FC No. 50-69C & 50-69 CX Cementitous Thermal Cladding for Structural Steel

Flame Control No. 50-69C and No. 50-69CX Cementitious Type Thermal Claddings contain no asbestos. They are formulated essentially out of fire inert inorganic materials; therefore, coated surfaces will not support combustion and are fire safe. No. 50-69C and No. 50-69CX offer an inexpensive way of affording permanent, lightweight, fire protection to interior and exterior structural steel through thermal insulation. They are supplied as dry materials that are mixed with water prior to application. Provides up to four hour Fire Rating.

flame control

flame control

FC No. 70 Intumescent Mastic for Cable Fire Protection

Flame Control No. 70 is a specially formulated, asbestos free, water base, reinforced intumescent fire retardant coating, designed primarily for use on electrical, communication cables and their supporting trays, where it is either necessary or desirous to increase their fire endurance time. When exposed to fire or high heat, the coating puffs up (intumesces), and forms a protective dense foam fire barrier, that shields the cables and trays, thereby retarding the penetrating of heat and propagation of flame. Specialty Construction Products No. 70 should be used where maximum fire protection is desired.

flame control

flame control

Installation for Flame Control Mastic No. 70

flame control

flame control

FC No. 77 Intumescent Mastic for Cable Fire Protection

No. 77 is a water based fire retardant coating compound from proprietary fire retardant resins, chemicals and nonasbestos reinforcing fibers. It has been designed for use on grouped electrical cables and their supporting trays. No. 77 prevents the propagation of fire along the cable surfaces and greatly increases the fire endurance time of supporting trays. No. 77 contains no flammable solvents and therefore, presents no fire hazard while being applied. However, due care must be exercised when applying No. 77, as it is a conductor of electricity while wet.

flame control

flame control

 

 

 

 

 

 

 

Site Mapflame controlHomeflame controlAbout Usflame controlContact Us flame controlDownloads flame controlDistributorsflame controlTest Videos flame controlSpecialty Construction Products
Fire Retardant Coatingsflame controlIndustrial Heat Resistant Coatings flame controlMetalsflame controlMasonryflame controlWoodsflame controlDrywall

4120 Hyde Park Blvd.flame control Niagara Falls, NY 14305flame control | flame controlPhone (716) 282-1399flame control | flame controlFax (716) 285-6303
flame control

flame control

NFPA Member Heat Resistant Paint

CSI Paint

Spray Polyurethane Foam